How do I control a computer AI agent using MemoMind One?

1. Open the MemoMind App.
2. Swipe left to open the sidebar, then select Settings.
3. Select Memo Lab > Memo Agent.

Configure an Agent
If you have not added an Agent before, select Add Agent.
- Select the AI agent you want to connect to.
- Enter the Memo Agent Name.
- Enter the Agent Host Address.
- Enter the Authentication Token.
- Tap Setup Guide for more detailed instructions.
Save the configuration when you are finished.

Supported Agent
Currently supported:
- Codex

How to use a configured Agent
After configuring an Agent, go to Memo Lab > Memo Agent again and select the Agent you added.
MemoMind One will display the Agent's conversation list. Exiting Memo Agent will also close the content displayed on MemoMind One.
When the conversation list is displayed:
- Single-click: Switch to the next conversation.
- Double-click: Confirm the selection.
- Press and hold for 2 seconds: Exit.
When viewing a conversation:
- Single-click: Go to the next page.
- Double-click: Go to the previous page.
- Triple-click: Return to the conversation list.
- Press and hold: Stop response.
Voice input and message confirmation
- Press and hold: Start voice input.
- Single-click: Switch options.
- Double-click: Confirm and send.

Notes:
- This feature currently requires your phone and computer to be connected to the same Wi-Fi network. If you need to access your computer from another network, tap Setup Guide and follow the Remote Access Guide.
- You cannot currently access Memo Agent directly through voice commands or Quick Launch. You must manually open the MemoMind App and go to Settings > Memo Lab > Memo Agent.